I always use “Safe removal” prior to removing any external device. The unit had not connected to Express I had just started express and the software was searching for the device. How do I determine if the unit is charging or fully charged when I can’t get past the splash screen. While it’s plugged in it continuously cycles between the splash screen and blank screen. I’ve charged the unit overnight with an AC USB charger. #GARMIN POI LOADER NOT WORKING WITH RV760 UPDATE#Software updates begin after the nuvi is disconnected from the computer and the software update therefore depends on the nuvi's internal battery to have sufficient charge to complete the software update. What were you doing with Garmin Express to the nuvi prior to the failure? If doing a software or map update with a weak battery, the update may have failed resulting in corrupt files. Is there any chance the computer/nuvi connection was lost while Garmin Express was still writing data to the nuvi? Do you "Safely Remove Hardware and Eject Media" when disconnecting the cable? You mention the failure first started when using Garmin Express. Charging with a USB charger for less than overight (or a vehicle cigarette lighter Garmin power cord for less than a couple/few hours) also is a cause of weak/dead battery issues. #GARMIN POI LOADER NOT WORKING WITH RV760 FULL#We've definitely had folks with problems like this due to a weak battery from a defective cable, burned out fuse, or power source that goes to sleep which was resolved once the nuvi's battery had a full charge. Are you charging via an AC USB charger, a computer USB port, or a vehicle cigarette lighter power cord through the nuvi cradle? Whichever method being used, make sure the nuvi is actually charging. Make sure the cable is good so the nuvi is actually charging. I suggest giving the nuvi a full overnight charge, then trying to start it before looking towards more drastic measures, especially with a newer model like the RV760. I'm not clear if your battery is fully charged or if you're relying on the external charger. This problem started while connecting to Garmin Express. 20 seconds)this is the same as when plugged into usb of computer. Upon first plugging into the charger the unit started to boot, and is cycling with splash screen then going blank continuously (the cycle rate is approx.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |